4x / 6x Load Container Bag Lifting Performance Test

4x / 6x Load Flexible Intermediate Bulk Container Performance TestFlexible FIBC Lifting and Dropping Testing Machine

Limited-use FIBC 70-cycle loading tester, disposable FIBC 30-cycle repeated lifting tester

Periodic lifting test for FIBCs, FIBC pressurization, dropping test

I. Product Introduction

The FIBC lifting and dropping testing machine is mainly used to test flexible intermediate bulk containers (with volumes between 0.5-2.3 m³ and load capacities between 500-3000 kg). Its main functions include performing 30 or 70 cycles of periodic lifting tests, pressure-holding tests with set load force values, and dropping tests for FIBCs.

Standards:

GB/T10454-2000 "Flexible Intermediate Bulk Containers"

SN/T3733-2013 "Flexible Intermediate Bulk Containers - Cyclic Top Lifting Test Method"

SN/T4788-2017 "Flexible Intermediate Bulk Containers - Top Lifting Test Method"

II. Features

1. This machine uses a high-precision load sensor to measure test force values, a hydraulic servo system to transmit power, and a computer to automatically control, collect, process, and store test data, with a printer to output test results. It automatically controls, collects, processes, analyzes, and statistically evaluates data, automatically determines pass/fail status, and outputs test curves and reports.

2. Suitable for square and round FIBCs with volumes between 0.5-2.3 m³ and load capacities of 500-3000 kg.

3. High-precision servo valve and force sensor enable test force holding at any point, time holding, loading, and pressure-holding control.

III. Technical Parameters

Test force: 200 kN

Test force measurement range: 0-200 kN; 0-100 kN; 0-40 kN; 0-20 kN in four ranges. Automatic range switching.

Test force accuracy: Better than ±1%

Equipped with force overload protection

Hydraulic piston stroke for loading: 800 mm

Platen size: Φ800 mm

Loading speed: 0~100 kN/min

Sling suspension point circumferential distribution: 4 equal divisions

Test FIBC diameter range: φ600-1200 mm

Test FIBC bag height: 500-2000 mm

Cycle count, holding load, and safety factor can be set arbitrarily, meeting 70-cycle and 30-cycle lifting tests, force holding tests, and destructive tests.

Power supply voltage: 380V/220V, 50Hz

IV. About the Tests

Full bag test method: Complies with GB/T10454-2000 "Flexible Intermediate Bulk Containers"

1. Periodic Lifting Test:

Fill the FIBC evenly with contents to full load, attach a load equivalent to twice the maximum payload. Perform seventy lifts for limited-use bags and thirty lifts for disposable bags. The FIBC passes if no abnormalities occur in the contents or bag body, and no damage is found at the connections.

2. Pressurization Test:

Place the fully loaded FIBC on the pressurization machine. Apply pressure equivalent to four times the full load weight of the FIBC, or use a static load method equivalent to the self-weight of four layers of fully loaded bags. Maintain pressure for eight hours or more. The FIBC passes if no contents spill and the bag body remains undamaged.

3. Vertical Drop Test:

Lift the fully loaded FIBC with lifting equipment so that the bottom is at least 0.8 m above the ground, then drop it vertically once onto a hard, flat surface. The FIBC passes if no contents spill and the bag body remains undamaged.

4. FIBC Safety Factor Test: Top Lifting Test (load bearing/rated load, 6x load, constant load pressure holding time ≥5 min).